Printed on Prusa i3 MK3S
Sliced with PrusaSlicer

Warnings:
These prints take a substantial amount of filament and time, make sure that you have enough of both before proceeding. You will most likely need multiple print files.

Parts:
2x ExtHooks (Extended Hooks)
1x Hook
1x Lid
1x Base

Print Settings:
0.2mm QUALITY Preset
Generate Support Material: True
Overhang Threshold: 45
Z Contact: 0.25
Top Interface Layers: 4
Pattern Spacing: 3
Support Style: Organic
XY Separation Between Object and Support: 75%
Maximum Branch Angle: 35
Preferred Branch Angle: 10
Branch Diameter: 3
Tip Diameter: 0.6
XY Separation Between Object and Support: 75%
Support on Build Plate Only: True

Infill Settings:
Base and Lid - 15% Gyroid
Hooks and Pin - 100% Rectilinear

Print Orientation:
The two halves should be printed laying flat, if possible. In the case that they can't, rotate them appropriately so they fit on the build plate. Do not rotate further than 45 degrees. Please use a brim and supports on these parts.
The hooks should be printed with the "alignment edge" up.
The pin should be printed on its head standing up, ensure that you use a brim (Used 10mm) with this part.

Assembly:
Insert the three hooks into the base. The two extended ones on the outside with the remaining in the middle. These should only be able to go in one orientation unless forced.
Place M1 or M2 Mac Mini into the holster.
Attach the lid, there are strong clips so it may need some pressure to put on. This shouldn't be the case but if the part feels like its going to snap, disassemble and sand the clips.
Insert the pin from either side.
Hook the holster onto to your TALINO.