Printed on Pruse i3 MK3S
Sliced with PrusaSlicer

Warnings:
You will most likely need multiple print files.

Parts:
2x Hooks
1x Lid
1x Base

Print Settings:
0.2mm QUALITY Preset
Generate Support Material: True
Overhang Threshold: 45
Z Contact: 0.25
Top Interface Layers: 4
Pattern Spacing: 3
Support Style: Organic
XY Separation Between Object and Support: 75%
Maximum Branch Angle: 35
Preferred Branch Angle: 10
Branch Diameter: 3
Tip Diameter: 0.6
XY Separation Between Object and Support: 75%
Support on Build Plate Only: True

Infill Settings:
Base and Lid - 15% Gyroid
Hooks and Pin - 100% Rectilinear

Print Orientation:
The base and lid should be printed laying flat. Please use supports on the base where needed.
The hooks should be printed flat with the "alignment edge" up.
The pin should be printed on its head standing up, ensure that you use a brim (Used 10mm) with this part.

Assembly:
Insert the two hooks into the lid. These should only be able to go in one orientation unless forced.
Place M4 Mac Mini into the holster.
Attach the lid, there are clips so it may need some pressure to put on. This shouldn't be the case but if the part feels like its going to snap, disassemble and sand the clips.
Insert the pin from either side.
Hook the holster onto your TALINO.