sumuri

Back to 3D Design

Cellphone Mount

A mount for holding a cellphone or similar device. It includes a small shelf below it, as well as legs allowing it to be placed on a desk if desired. A hole in the center of where the phone sits allows for plugging the phone in while using the mount. Be aware some phones might be too thick to fit when inside a particularly large case.


Print Settings Used:

  • Printer used: JGAURORA A5S
  • Supports: Yes
  • Infill Density: 50%
  • Build Plate Adhesion: Skirt
  • Filament Type: PLA

Set other settings as needed for printer and filament used.

Print on face down side of STL file. Some sanding and/or trimming may be required.


Total Downloads:
246 Downloads
Scroll to Top